Panel, battery, motor: how does a solar roller shutter work?
It works as a closed loop: the panel captures daylight, the battery stores the energy and the motor uses it each time the shutter goes up or down. No wire links the shutter to the house’s fuse board, and it is controlled by radio.
The photovoltaic panel
Usually fixed to the front of the shutter box, it produces power as soon as it receives light, even diffuse light.
Watch out for: shade from a balcony, a tree or overhanging eaves.The battery
Housed in or next to the box, it stores energy for evening operation and dull days.
Good to know: it is a wearing part and can be replaced.The tube motor
Fitted inside the roller tube, it runs on low voltage and has a built-in radio receiver.
Sign of wear: the shutter slows down or stops partway.Wireless control
Remote control, wireless wall switch, or both. Several shutters can be grouped together.
First thing to try: change the remote’s battery.Why choose a solar roller shutter over a mains-wired electric one?
Because it avoids all the electrical work: no channels cut in the plaster, no cable to the fuse board, no 230 V connection to arrange. It is the simplest way to motorise a house that is already lived in, a window far from any socket or an outbuilding.
| Solar shutter | Mains-wired electric shutter |
|---|---|
| No wiring, fitted without indoor works | Power supply to be run to the shutter |
| Keeps working during a power cut as long as the battery is charged | Stops if the mains goes off |
| Depends on the light the frontage receives | Independent of orientation |
| Battery to replace over the years | No battery to look after |
The mains-wired shutter is covered on our electric window shutter page. To equip an existing shutter, see window shutter motorisation.
Does a solar roller shutter work well in Normandy?
Yes, provided the panel gets daylight without lasting shade: a photovoltaic panel still produces under an overcast sky, just less than in full sun. The battery is there to smooth out grey days and short winter days.
What really matters is the window’s orientation and its surroundings. A north-facing wall, a window under a deep balcony or a narrow street can limit charging. During the survey we look at how each window is exposed before recommending solar or wired, without pushing you either way. For a poorly exposed frontage, a back-up charging solution can be offered: it is set out during the site survey.
On the coast, from Le Havre to Dieppe or in the Manche department, salty air leaves a film on the panel: an occasional rinse with clean water helps it keep its output.
Which windows suit a solar shutter?
It can be fitted on new builds and renovations alike, since its external box is fixed to the outside wall, with no channels or cable runs through the walls. We fit solar shutters made to measure to the dimensions taken by the technician, and we replace solar batteries and motors on existing shutters, all makes.
- Older houses where you do not want to damage walls or ceilings.
- Roof windows and isolated gable walls, far from the fuse board.
- Second homes on the coast, closed for part of the year.
- Replacing a manual shutter whose strap or crank is wearing out: see our retrofit roller shutter page.
Measuring up and choosing slats and colours are covered on the made to measure roller shutter page, and the fitting process on the window shutter installation page.
What should you do if your solar shutter stops responding?
Start with the remote’s battery, then check that the panel is neither dirty nor shaded. If the shutter is still unresponsive after a few days of daylight, the battery or the motor is at fault. Do not take the box apart; call us instead: a technician answers, just as for our emergency roller shutter repair. Our window shutter work is described on the window shutter repair page, around Rouen, Le Havre and Caen. Every type is compared on our window roller shutters page.
