How does a cantilever gate work?
The leaf has a bottom beam that slides through two roller carriages set on a concrete base beside the opening. Extended at the back by a counterbalance section (called the tail), it stays suspended above the entrance without touching the ground. At the top, a guide post keeps it upright; when closing, it rests in a receiving post.
That rear section is what sets it apart from a sliding gate on a track: it balances the leaf's weight, but needs more free length along the fence.
Why choose a cantilever gate?
Because the entrance stays completely clear: nothing to cross, nothing to clog, nothing to freeze in the threshold.
| Strengths | Weaknesses |
|---|---|
| No track across the entrance: trolleys, bikes and lorries pass freely | Longer run-back (storage) length than a standard sliding gate |
| Unaffected by gravel, mud, leaves and snow | Concrete base needed to one side, sized for the leaf |
| Suits uneven or cambered ground in the entrance | Heavier structure, best left to an equipped installer |
| Suited to wide openings and heavy use | Carriages and rollers need regular checks |
Which sites is a cantilever gate suited to?
The cantilever gate is first and foremost a business gate, but it also appeals to homeowners with an unsurfaced drive.
- Warehouses and business parks: lorries and forklifts, which would soon damage a track. The site's other closures (warehouse shutters, industrial doors) can be looked after by the same technician.
- Residential, shop or company car parks: many cycles a day, motorisation and access control essential.
- Farms and gravel yards: soft or muddy ground does not affect rolling.
- Houses with a gravel drive: the threshold stays clean, with no groove for stones to jam in.
DEPANN'Rideaux fits, motorises and repairs cantilever gates of all makes, including the extra-long models used on business sites. The leaf is made to measure from the dimensions taken by the technician during the site survey.
Steel or aluminium for a cantilever gate?
Wide business openings are often galvanised steel, more rigid over a long span; aluminium lightens the leaf for a house or residential car park. On a site near the sea, in Le Havre, Fécamp or Cherbourg, corrosion protection for the carriages and screws matters as much as for the leaf. The full comparison is on our metal gates page.
How do you motorise and maintain a cantilever gate?
Like a sliding gate, it is driven by a rack-and-pinion motor on a plinth. In a workplace, it is subject to the mandatory periodic inspections for automatic gates: see our guide to mandatory maintenance. Maintenance covers the carriages, guide rollers, rack, motor and safety devices (photocells, safety edges, light). More on the electric gate motors page.
How is it installed, and what if it breaks down?
Installation starts with a site survey, which is free: available length, type of ground, position of the base, power supply. A concrete base is poured and must cure before the carriages and leaf are fitted; then come adjustment and commissioning. The full process is on the gate installation page.
If it breaks down (leaf leaning, noisy rollers, motor straining), do not force it: see gate repair. We work across Normandy, from Rouen to Caen and from Cherbourg to Alençon. On the phone, you describe the fault and find out when we can arrive; the technician gives you the price on site, after the diagnosis and before any work starts.
