How does a roller garage door work?
The principle is that of an enlarged window shutter: horizontal slats, usually aluminium, interlock to form a flexible curtain. As it opens, it rises in two side guide rails and rolls onto a barrel housed in a box above the opening. When closed, the door comes down to a bottom slat fitted with a seal that follows the floor.
The box sits inside the garage, under the lintel, or outside when there is not enough room inside. Operation is almost always electric, with a motor inside the barrel; manual models with a strap or winch exist but are rarer on wide openings. It belongs to the same family as the garage roller shutter used in workshops, in a lighter version designed for the home.
Which garages suit a roller door?
Choose it when the garage is short of space on the ceiling or at the sides: that is its great advantage over other doors.
- Cluttered ceiling: beams, ducts, a boiler, a mezzanine or hanging storage that sectional door tracks would get in the way of.
- Shallow garage, where the car only just fits and the door must not take up any room.
- Low or sloping ceiling, under a converted room or in a basement.
- Opening onto a street or pavement, where nothing must swing out while the door moves.
What are the pros and cons of a roller garage door?
It wins on space and loses a little on insulation and clear height. An honest assessment:
| Strengths | Weaknesses |
|---|---|
| No use of ceiling or side walls | The box slightly reduces clear height if fitted under the lintel |
| Vertical opening, nothing swings outside | Thin slats: generally less insulating than a sectional door with thick panels |
| Motor inside the barrel, discreet and compact | No built-in pedestrian door: you have to open the door to walk in |
| A damaged slat can often be replaced without changing the curtain | Without a motor, a wide door becomes hard work |
If your ceiling is clear and insulation comes first, look at the sectional garage door. If a side wall is free, the side-sliding door allows pedestrian access.
Does a roller door stand up to the Normandy climate?
Yes, provided you choose well-protected slats and keep the guide rails clean. Powder-coated aluminium copes well with damp; by the sea, in Le Havre as in Dieppe, salt air mainly attacks the fixings, the guide rails and the bottom of the curtain, where sand and water build up. Against the wind, a wide door must be held firmly in its guide rails: wind locks on the slat ends, depending on the model, reduce vibration.
What options are there for your roller garage door?
We supply and fit new roller garage doors, made to measure from the dimensions taken by the technician, with slats chosen from the ranges of the major brands on the market. The slats and colours available for your door are shown to you during the site survey.
What faults affect a roller garage door?
The most common faults are a motor that no longer responds, a slat knocked out of its guide rail and a door that stops halfway because of a safety device. Never force the door by hand and do not open the box: the barrel and motor are a job for a technician.
We repair roller garage doors, from Rouen to Cherbourg: see garage door repair. The technician gives you the price on site, after the diagnosis and before any work starts. For a new door, the site survey is free; the other models are compared on our garage doors and residential doors page.
