The shutter will not come down: what should you do until we arrive?
Your priority is to protect the premises without making the fault worse. These steps need no tools and involve no risk.
- Do not leave the premises unattended. Stay on site or get someone to take over, and put the till and valuable stock away in a locked room.
- Switch off the power at the circuit breaker if the motor is straining, overheating, humming or smells of burning. A motor that keeps pushing against a blockage will end up burning out.
- Do not pull on the curtain. Bringing it down by hand can pull it out of the guide rails or make it drop all at once.
- Look without touching the mechanism. Is there an object under the shutter, a safety sensor that is covered, the emergency stop button pressed in, flat remote batteries?
- Photograph the shutter and call +33 7 68 20 39 55. The technician prepares the closing solution before setting off.
Why is a shutter stuck open the most critical emergency?
Because a shop that will not close stays open to anyone, all night. Your stock, your till and your equipment are exposed to theft and damage.
There is also the question of insurance. Many policies make theft cover conditional on all access points actually being closed: reread the terms of yours or ask your insurer. If you need to make a claim, keep the photos of the stuck shutter and the detailed invoice for our call-out, which describes the fault found and the work carried out. If the problem follows an attempted break-in, see our page shutter forced after a break-in.
Why is my roller shutter stuck open?
A roller shutter stuck open almost always comes down to a problem with the motor, the guiding or the safety devices. Here are the causes our technicians come across most often, with the sign that helps you recognise them.
Limit switch out of adjustment
The motor thinks the shutter is already down, or no longer receives the position information: it refuses to go down or stops too early.
Sign: the shutter started stopping higher and higher, then stopped moving altogether.Motor failure
A dead capacitor, burnt-out winding or tripped thermal cut-out: the motor no longer has the power to turn the axle.
Sign: humming with no movement, or no sound at all. See motor failure.Electromagnetic brake stuck
The brake holds the curtain in position. If it no longer releases, the motor cannot start the descent.
Sign: a click each time you press the control, then nothing.Slat jammed crosswise in the guide rails
A bent slat, or one that has come out of its housing, jams the curtain in the rails, often after a knock or an attempted break-in.
Sign: the shutter is at an angle, a slat sticks out. See bent or broken slats.Cable, strap or winch
On shutters operated by strap or winch, a broken strap, a detached cable or a worn-out winch prevents any controlled descent.
Sign: the crank or the strap turns without catching.Obstacle, sensor or controls
An object under the shutter, a dirty or misaligned photoelectric sensor, a damaged safety edge or a faulty control box stops the descent as a safety measure.
Sign: the shutter comes down a few centimetres then goes back up. See remote or control box not working.Damaged axle or spring
A warped axle, a seized bearing or a broken spring unbalances the winding: the curtain no longer unrolls normally.
Sign: a sharp crack in the shutter box, a shutter that leans. See axle, springs and guide rails.How do we secure your premises at night?
Our aim at night is simple: your premises are closed or protected before the technician leaves, even if it means coming back the next day for the permanent repair.
- 1Call and safety adviceYou describe the situation to the technician, who identifies the likely cause, gives you safety advice and the arrival time, then prepares the parts needed.
- 2Diagnosis, price and closingOn site, the technician makes the diagnosis and gives you the price before any work starts. Then adjusting the limit switches, manual override if the motor has one, putting a slat back in its rail or replacing a part carried in the van.
- 3Making safe if it cannot be closedIf a part is missing, the curtain is safely immobilised and access is protected temporarily: temporary locking, locking the shutter out of use or, if it can no longer come down, fitting temporary boarding on a quote.
- 4Permanent repairA scheduled return visit with the part, full testing and a detailed invoice.
To secure your shop fully, see also our making safe service and our night call-out.
What is the temporary fix, and what is the permanent repair?
The temporary fix closes the premises tonight; the permanent repair removes the cause so the shutter does not stick again. Depending on the fault, both are sometimes done in a single visit.
| Cause | The same night | Permanent repair |
|---|---|---|
| Limit switch out of adjustment | Adjustment and lowering the shutter | Checked adjustment, replacing the limit switch unit if worn |
| Motor or capacitor | Manual override or replacing the capacitor | Repair or replacement of the motor |
| Brake stuck | Releasing the brake and closing | Replacing the brake or the motor |
| Slat jammed crosswise | Putting the slat back in its rail or removing it | Replacing the damaged slats |
| Axle or spring | Immobilising the curtain and protecting access | Replacing the axle or springs |
How much does a call-out for a shutter stuck open cost?
The price depends on the cause and the time of day.
Price given on site, before any work starts. On the phone, describe the fault to the technician (a photo helps) so he arrives with the right parts. On site, he makes the diagnosis and tells you the price before starting: nothing is done without your agreement, and you get a detailed invoice at the end. How the price of a repair is set.
What makes the price vary?
- The cause of the problem: adjusting limit switches is quicker than releasing a brake or putting a crooked curtain back in its rails.
- The closing solution: bringing the shutter down that same evening, or fitting temporary boarding, on a quote, if the curtain can no longer come down.
- The parts to replace: a capacitor, brake, slats or motor come on top of the call-out.
- The time of day: a shutter left open in the evening often means a night call-out, which carries a surcharge, as do Sundays and bank holidays.
- The distance: the call-out charge depends on the distance from our base in Gruchet-le-Valasse and is given to you together with the price of the job.
Where do we come out for a shutter left open?
Anywhere in Normandy, by day and by night, including:
How can you avoid the shutter staying open one evening at closing time?
By watching for the warning signs: a shutter that stops a little higher each day, a slower motor, a slat that rubs. These symptoms are easily put right during a maintenance visit. Our guide to looking after a roller shutter sets out what to keep an eye on, and every other emergency is on our emergency roller shutter repair in Normandy page.
