How is a tube and link grille built?
A tube and link grille is an open curtain made of horizontal metal tubes, joined together by links that give it a wavy look. Instead of the slats of a standard shutter, it is these tubes that roll up onto the axle, inside a shutter box above the opening. At the sides, the ends of the tubes slide in guide rails; at the bottom, a bottom slat takes the lock or bolts.
In France it is often called a “cobra” grille; it is also known as a link grille or roller grille.
Why fit a tube and link grille rather than a solid shutter?
To keep your window almost fully visible and your premises ventilated, while keeping everyone out when the shop is closed.
What are the limits of a tube and link grille?
It stops people getting in, but it neither protects the glass nor hides the interior. Before choosing one, bear in mind that:
- The glass remains exposed to thrown objects, liquids and thin objects slipped between the tubes.
- Rain and wind get through: in front of a street-facing window, the glass door must be watertight and properly shut.
- Your stock can be seen: valuable items must be put out of sight in the evening.
- An impact can break a link or bend a tube, which then catches in the guide rails.
If the glass needs protecting, look instead at the micro-perforated roller shutter or the solid slat roller shutter.
Where should a tube and link grille be fitted?
It belongs where it is sheltered from the weather, or where you want people to see through.
- Shops in arcades and shopping centres, where the walkway stays lit at night. See our advice on shop roller shutters.
- Inside the shop, behind the window, or to close off a counter, a bar or a sensitive section.
- Premises that need ventilating: stockrooms, car parks, storage areas. See warehouse roller shutters.
By the sea, in Le Havre or Cherbourg, salty air attacks metal: we offer galvanised and powder-coated finishes, and rinsing regularly with clean water helps preserve the grille.
What options are there for a tube and link grille?
Like a shutter, a tube and link grille can be ordered with manual or electric operation.
- Manual: counterbalanced by spring boxes, locked with a central lock or side bolts.
- Electric: motor, with key switch, push-button control box or remote control. See the electric roller shutter.
- Finish: galvanised, or powder-coated in a colour from our supplier’s RAL chart, on quotation. The material depends on our suppliers’ models and is stated in the quote.
How are fitting and maintenance handled?
The grille is made to measure after the opening has been surveyed, and fitted either on the face of the wall in front of the opening or within the reveal between the walls. We check the space available for the shutter box and how solid the supports are, then make the grille to size: see made-to-measure shutters and our roller shutter installation section.
In use, keep an eye on the links and the alignment of the tubes. A bent tube or broken link can usually be replaced on its own, without changing the whole grille. If the grille catches, stops coming down or hangs lower on one side, stop operating it and call us: see bent or broken curtain. Our guide to looking after your roller shutter applies to grilles too.
All the other options are compared on our shutters and grilles page.
